Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie


Bewerken van stap 3 —

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 6 handleidingen die deze stap bevatten.

Stap type:

Sleep om te herschikken

Heat an iOpener and apply it to the same edge of the phone for two minutes.

Apply a suction cup to the back of the phone, as close to the center of the right edge as possible (where the adhesive is narrowest).

Pull on the suction cup with strong, steady force to create a gap between the back cover and the frame.

Insert the point of an opening pick into the gap.

Due to tight tolerances, this may take multiple attempts.

If you are having trouble creating a gap, your best bet is to apply more heat to the edge and try the previous step again.

You can try applying a few drops of high concentration (over 90%) isopropyl alcohol into the seam to help loosen the adhesive.

Do not apply excessive force with the pick, or you will risk cracking the back cover glass.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.