Ga door naar hoofdinhoud
Help
Bewerken van stap 6 —

Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 2 handleidingen die deze stap bevatten.

Stap type:

Sleep om te herschikken

Your replacement part may or may not come with the front (sensor) bracket. If it does not, you'll need to transfer it to your new cable.

Use the tip of a spudger to flip the "lever" of the ZIF connector (left side in first photo) on the hard drive cable. The connector does not come off, see next instruction.

Gently pull the yellow sensor bracket cable out of the ZIF connector (to the right, in the second photo).

Use the flat end of a spudger to pry the hard drive cable up off the sensor bracket to which it is adhered.

Remove the adhesive backing from your new hard drive cable, stick it onto the sensor bracket, and connect the sensor bracket cable.

Many fixers cover the length of the thicker cable in the pair with sections of electrical tape on both sides because it can rub the tiny ridges inside the aluminum case causing a short to the case itself or simply breaking the connection.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.