Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie


Wijzigingen aan stap #2

Bewerking door Christopher Hill

Bewerking geweigerd door Jake Devincenzi


Stap regels

[* black] Disconnect the microphone cable connector, removing tape as necessary.
[* icon_reminder] For the front bezel to sit properly, be sure to tuck the microphone cable and connector into the void next to the camera board.
[* black] If you are not removing the bezel, but just trying to access the internals, then you can leave the microphone cable attached and just lift the bottom of the bezel up and over the computer so that it rests face down. There is enough microphone cable to allow them to remain connected if you have the room.