Ga door naar hoofdinhoud

Wijzigingen aan stap #2

Bewerking door Jake Devincenzi

Bewerking goedgekeurd door Jake Devincenzi

Voor
Na
Ongewijzigd

Stap regels

[* black] Carefully lay the iMac stand-side down on a flat surface.
[* icon_note] Due to tight tolerances, you will have to use a thin hooked tool to lift the display out of the outer case. As seen in the third picture, we made one out of a bent paperclip.
-[* black] Use a thin hooked tool to lift one side of the TOP edge (picture is upside down) of the display by its steel outer frame.
+[* black] Use a thin hooked tool to lift one side of the top edge of the display by its steel outer frame.
[* icon_note] After lifting the top edge of the display on one side, hold it out of the outer case while you use a hooked tool to lift the other side.
[* icon_caution] Do not lift the top edge of the display out of the outer case too far, as several short ribbon cables still connect the two components.