Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #5

Bewerking door Matt Barnes

Bewerking goedgekeurd door Matt Barnes

Voor
Na
Ongewijzigd

Stap regels

[* icon_reminder] Allow the EMI shield to hang down from the display.
[* red] Remove the four 8 mm with 2 mm thick head coarse-thread T10 Torx screws securing the display to the rear case.
[* icon_note] These screws are recessed, so a thin screwdriver such as [product|IF145-014|thisproduct|IF145-080|this] is essential for removal. Bit drivers tend to be too short for this application.
[* icon_note] These screws are recessed, so a thin screwdriver such as [product|IF145-014|thisproduct|IF145-080|this] is essential for removal. Bit drivers tend to be too short for this application.
[* icon_note] It is strongly recommended to use a magnetized screwdriver so the screws won't fall into the iMac.