Ga door naar hoofdinhoud

Wijzigingen in stap #5

Bewerken voor Andrew Bookholt

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* icon_reminder] Allow the EMI shield to hang down from the display.
[* red] Remove the four coarse-thread T10 Torx screws securing the display to the rear case.
[* icon_note] These screws are recessed, so a thin screwdriver such as [product|IF145-014|this] is essential for removal. Bit drivers tend to be too short for this application.
[* icon_note] It is strongly recommended to use a magnetized screwdriver so the screws won't fall into the iMac. Note: when screws fall into the iMac, it's really difficult to get it out!!
[* icon_note] It is strongly recommended to use a magnetized screwdriver so the screws won't fall into the iMac. Note: when screws fall into the iMac, it's really difficult to get it out!!