Ga door naar hoofdinhoud

Wijzigingen aan stap #4

Bewerking door Arthur Shi

Bewerking goedgekeurd door Arthur Shi

Voor
Na
Ongewijzigd

Stap regels

-[* icon_caution] Be careful not to damage the connector when performing this step.
-[* black] Use the spudger or your fingernail to lift off the connector that holds the screen in place.
-[* black] Lift off the display assembly completely and place it off to the side.
-[* icon_reminder] Gently scrape any remaining adhesive from your phone. Use a small amount of high concentration isopropyl alcohol (at least 90%) to clean the frame and prep it for the new screen adhesive.
-[* icon_reminder] The replacement adhesive should only be applied to the edges of the frame, but may come with the center filled in.
- [* black] To remove the unnecessary center section of the adhesive strip, carefully peel away the perforated rectangle in middle of the white backing. At the same time, peel up the black adhesive underneath the white backing.
- [* icon_note] Only adhesive for the edges of the frame should remain.
+[* black] Use the point of a spudger to pry up and disconnect the interconnect cable from the bottom daughterboard.
+[* icon_note] You can leave the interconnect cable attached to the daughterboard via the adhesive, or you can completely remove it.

Afbeelding 1

Oude versie

Nieuwe versie

Afbeelding 2

Oude versie

Nieuwe versie