Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #7

Bewerking door Andrew Bookholt

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* black] Pull the optical drive up by its white pull tab to disconnect it from the logic board.
[* icon_caution] Lift the free end of the optical drive just enough to clear the fan cover. Lifting the free end of the optical drive too far may break the plastic positioning pins off the front bezel.
[*
black] PullLift the free end of the optical drive slightlyslightly, then pull it away from the frontedge of the rear case and lift itto clear the two plastic positioning pins.
[* black] Lift the optical drive
out of theyour iMac.
[* icon_reminder] When reinstalling your optical drive it may be necessary to set the bezel attached to the open end of the drive on the plastic positioning pins molded into the front bezel of the iMac and pull the connector side of the drive toward the edge of the rear case, bending it outward slightly, to properly seat the connector.
[* icon_caution] Lift the free end of the optical drive just enough to clear the fan cover. Lifting the free end of the optical drive too far may break the plastic positioning pins off the front bezel.
[*
black] PullLift the free end of the optical drive slightlyslightly, then pull it away from the frontedge of the rear case and lift itto clear the two plastic positioning pins.
[* black] Lift the optical drive
out of theyour iMac.
[* icon_reminder] When reinstalling your optical drive it may be necessary to set the bezel attached to the open end of the drive on the plastic positioning pins molded into the front bezel of the iMac and pull the connector side of the drive toward the edge of the rear case, bending it outward slightly, to properly seat the connector.