Ga door naar hoofdinhoud

Wijzigingen in deze stap

Bewerken voor Derek

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Disconnect the camera from the motherboard.
[* black]
There are 1.5mm gaps on either side of the connector between the connector and its port. Put the pointed end of the spudger in one gap at a time and use it to pry"walk" the connector out.
[* black] If
out by wedging out the connector has not beenon each side.
[* icon_note] If it is difficult to
fully priedpry out bythe connector with the spudger, you may remove it by hand by pulling it out, as shown in the pictures on the left.
[* black] Disconnect the camera from the motherboard.
[* black]
There are 1.5mm gaps on either side of the connector between the connector and its port. Put the pointed end of the spudger in one gap at a time and use it to pry"walk" the connector out.
[* black] If
out by wedging out the connector has not beenon each side.
[* icon_note] If it is difficult to
fully priedpry out bythe connector with the spudger, you may remove it by hand by pulling it out, as shown in the pictures on the left.