Ga door naar hoofdinhoud

Wijzigingen in stap #7

Bewerken voor Nick Hall

Bewerking geweigerd door Sam Goldheart

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Remove the following screws securing the logic board to the case:
[* red] One 2.5 mm Phillips screw near the vibrator motor
[* orange] One 2.4 mm Phillips screw was taken out before hand
[* orange] One 2.4 mm Phillips screw was taken out before hand
[* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening.
[* icon_note] Use a small flathead screwdriver to remove the single 3.6 mm standoff.