Ga door naar hoofdinhoud

Wijzigingen in stap #7

Bewerken voor Dominik Schnabelrauch

Bewerking goedgekeurd door Dominik Schnabelrauch

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Remove the following screws securing the logic board to the case:
[* red] One 2.5 mm Phillips screw near the vibrator motor
[* orange] One 2.4 mm Phillips screw
[* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening.
[* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriver toand [product|IF145-326|driver handle|new_window=true] to remove the single 3.6 mm standoff screw.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriver toand [product|IF145-326|driver handle|new_window=true] to remove the single 3.6 mm standoff screw.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.