Ga door naar hoofdinhoud

Wijzigingen in stap #7

Bewerken voor Walter Galan

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* redblack] Remove the 3.4following screws securing the logic board to the case:
[* red] One 2.5
mm Phillips screw near the vibrator motor.
[*
motor
[*
orange] Use a small flathead screwdriver to remove the twoOne 2.4 mm Phillips screw
[* yellow] One
3.6 mm standoffsstandoff along the side of the logic board nearest the battery opening.
[* icon_note] Use a small flathead screwdriver to remove the single 3.6 mm standoff.
[* redblack] Remove the 3.4following screws securing the logic board to the case:
[* red] One 2.5
mm Phillips screw near the vibrator motor.
[*
motor
[*
orange] Use a small flathead screwdriver to remove the twoOne 2.4 mm Phillips screw
[* yellow] One
3.6 mm standoffsstandoff along the side of the logic board nearest the battery opening.
[* icon_note] Use a small flathead screwdriver to remove the single 3.6 mm standoff.

Afbeelding 1

Oude versie

Nieuwe versie