Repareer je spullen

Recht op reparatie

Winkel

Wijzigingen aan stap #9

Bewerking door Jeff Suovanen —

Bewerking goedgekeurd door Jeff Suovanen

Voor
Na
Ongewijzigd

Stap regels

[* black] Use the edge of a plastic opening tool to gently pry up the display assembly around its perimeter.
[* black] Remove the display assembly from the iPhone.
[* icon_caution] When reinstalling the display assembly, make sure the digitizer and display data cable are completely pulled through the slot cut into the outer case. Otherwise, the digitizer cable will not reach to its socket on the logic board.
[* icon_note] Remember to [guide|7282|switch the home button|stepid=31173] from your old display to the new display (in most cases, this is not provided). The home button gasket is thin rubber, so care must be taken not to tear it, or it won't work when transferred. Also check that the mesh for the speaker hole is present in the replacement; if not, move it over from the old display.
[* black] Be sure to peel off the protective backing (usually pink or blue) from the new panel before installing it.
[* black] When reassembling, if your replacement display does not come with a 7mm7 mm clear plastic ring surrounding the front facing camera, be sure to transfer it between the old and new display.
[* icon_reminder] After reassembly, clean the touchscreen surface with an alcohol wipe prior to turning the iPhone back on. The alcohol helps dissipate any lingering static electricity, which can cause problems with the display.
[* icon_caution] After reassembly, connect the iPhone to an AC power source before turning it on for the first time. Once the iPhone has booted up successfully, you can disconnect the AC power.
[* icon_note] After reassembly, protect your new display from any scratches by installing a new [product|IF182-025|screen protector].
[* icon_caution] When reinstalling the display assembly, make sure the digitizer and display data cable are completely pulled through the slot cut into the outer case. Otherwise, the digitizer cable will not reach to its socket on the logic board.
[* icon_note] Remember to [guide|7282|switch the home button|stepid=31173] from your old display to the new display (in most cases, this is not provided). The home button gasket is thin rubber, so care must be taken not to tear it, or it won't work when transferred. Also check that the mesh for the speaker hole is present in the replacement; if not, move it over from the old display.
[* black] Be sure to peel off the protective backing (usually pink or blue) from the new panel before installing it.
[* black] When reassembling, if your replacement display does not come with a 7mm7 mm clear plastic ring surrounding the front facing camera, be sure to transfer it between the old and new display.
[* icon_reminder] After reassembly, clean the touchscreen surface with an alcohol wipe prior to turning the iPhone back on. The alcohol helps dissipate any lingering static electricity, which can cause problems with the display.
[* icon_caution] After reassembly, connect the iPhone to an AC power source before turning it on for the first time. Once the iPhone has booted up successfully, you can disconnect the AC power.
[* icon_note] After reassembly, protect your new display from any scratches by installing a new [product|IF182-025|screen protector].

Afbeelding 1

Oude versie

Nieuwe versie

Afbeelding 2

Oude versie

Nieuwe versie

Afbeelding 3

Geen vorige afbeelding

Toegevoegd