Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #7

Bewerking door raffaele

Bewerking geweigerd door Jake Devincenzi

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Peel up the orange Kapton tape securing the rightmiddle thermal sensor cable to the logic board.
[* black] Remove the following 15 screws:
[* red] One 4.4 mm black Phillips screw to the right of the ram slot.
[* orange] Eight 4.7 mm silver T6 Torx screws securing the logic board to the lower case.
[* yellow] One 6.2 mm black T6 Torx screw on the right side of the left fan.
[* green] Five 9.4 mm silver T6 Torx screws securing the left and right fans.
[* black] Peel up the orange Kapton tape securing the rightmiddle thermal sensor cable to the logic board.
[* black] Remove the following 15 screws:
[* red] One 4.4 mm black Phillips screw to the right of the ram slot.
[* orange] Eight 4.7 mm silver T6 Torx screws securing the logic board to the lower case.
[* yellow] One 6.2 mm black T6 Torx screw on the right side of the left fan.
[* green] Five 9.4 mm silver T6 Torx screws securing the left and right fans.

Afbeelding 2

Verwijderd