Ga door naar hoofdinhoud

Wijzigingen aan stap #4

Bewerking door Paige Reisman

Bewerking goedgekeurd door Paige Reisman

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* icon_note] If you successfully removed all three adhesive strips, move on to the next step. Otherwise, you will need to pry the battery from the rear case.
[* black] [guide|25705|Prepare an iOpener|new_window=true] and apply it to the back of the rear case, directly over the battery. Alternatively, you can apply heat using a heat gun or hair dryer.
[* black] After about a minute, remove the iOpener, flip the phone over and slide a plastic card underneath the battery to break up any remaining adhesive behind the battery.
[* black] After about a minute, remove the iOpener, flip the phone over and slide a plastic card underneath the battery to break up any remaining adhesive behind the battery.
[* icon_caution] Do not insert the card from the right, as prying against the logic board can damage it. Also, be sure to not bend the battery, as doing so can puncture the cell and release dangerous chemicals.