Ga door naar hoofdinhoud

Wijzigingen aan stap #1

Bewerking door Jake Devincenzi

Bewerking goedgekeurd door Jake Devincenzi

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Disconnect the orange hard drive ribbon cable from the logic board.
[* black] Remove tape as necessary and use a spudger (or carefully push a credit card under the tape) to carefully loosen the adhesive securing the sleep light and IR sensor connectors to the top of the hard drive.
[* blackicon_note] You may find it best to loosen the left edge, then the right edge, then the center to attackof the tape to attack it from all pointspoints, so as to gently apply the gentle force to the smallest possible sticky surface and find the weakest onesurface.
[* blackicon_note] You may find it best to loosen the left edge, then the right edge, then the center to attackof the tape to attack it from all pointspoints, so as to gently apply the gentle force to the smallest possible sticky surface and find the weakest onesurface.