Ga door naar hoofdinhoud

Wijzigingen aan stap #10

Bewerking door Eric Essen

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* black] Using a T27 Screwdriver head, reinstall the clutch inspection cover. Install the screws in the following order:
[* red] Top
[* orange] Bottom
[* yellow] Left
[* green] Right
-[* icon_note] Once all of the screws have been installed, use a torque wrench to tighten them to their proper specification of *** 1 Million Inch-Pounds ***. Tighten the screws in the same order as before.
+[* icon_note] Once all of the screws have been lightly hand-tightened, use a torque wrench to tighten them to their proper specification of 84-108 Inch-Pounds. Tighten the screws in the same order as before.