Ga door naar hoofdinhoud

Wijzigingen in stap #36

Bewerken voor David Hodson

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Use a pair of cutting pliers to cut oneremove about an inch of the surface-mounted leads down to a length where you can bend it through the nearest hole in the battery contact with about 6 or 7 millimeters left overpositive terminal surface mount wire leads.
[* black] After bendingBend the wire lead around and through the hole, usepositive ring terminal on the samebattery compartment.
[* black] Use your now perfected
through-hole soldering technique as earlierskills to solder the batterywire lead to the hole in the battery contactterminal.
[* black] Cut any excess wire from the lead
.
[* black] Use a pair of cutting pliers to cut oneremove about an inch of the surface-mounted leads down to a length where you can bend it through the nearest hole in the battery contact with about 6 or 7 millimeters left overpositive terminal surface mount wire leads.
[* black] After bendingBend the wire lead around and through the hole, usepositive ring terminal on the samebattery compartment.
[* black] Use your now perfected
through-hole soldering technique as earlierskills to solder the batterywire lead to the hole in the battery contactterminal.
[* black] Cut any excess wire from the lead
.