Ga door naar hoofdinhoud

Wijzigingen in stap #36

Bewerken voor Jake Devincenzi

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Use cutting pliers to cut one of the surface-mounted leadleads down to a length where you can bend it through the nearest hole in the battery contact with about 6 or 7 mmmillimeters left over.
[* black] Use cutting pliers to cut one of the surface-mounted leadleads down to a length where you can bend it through the nearest hole in the battery contact with about 6 or 7 mmmillimeters left over.
[* black] After bending the lead through the hole, use the same through-hole soldering technique as earlier to solder the battery lead to the hole in the battery contact.