Ga door naar hoofdinhoud

Wijzigingen aan stap #35

Bewerking door David Hodson

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

-[* black] Use a plastic spudger to pry the metal rings on the battery connectors up so that they are vertical.
- [* icon_note] These should be on the same end as the leads sticking out the sides of the circuit board. If they are on the opposite end, the board is on backwards. Unscrew the nuts and flip the board around.
+[* black] Use a spudger to pry the metal rings on the battery terminals up so that they perpendicular to the battery terminals.
+ [* icon_note] These rings should be on the same end as the surface mount leads. If they are on opposite ends, the board is on backwards. Unscrew the nuts, rotate the circuit board 180°, reinstall the nuts, and tighten the two screws.