Ga door naar hoofdinhoud

Wijzigingen aan stap #8

Bewerking door Ashley Ryan

Bewerking goedgekeurd door Evan Noronha


Stap regels

[* black] We all make mistakes, especially when trying something new. Soldering is no exception, so here's what to do when one of your soldered joints comes out less than ideal.
[* black] Lay a strand of desoldering braid over the solder in question. Press the tip of the soldering iron firmly onto the desoldering braid. This will heat up both the solder and the braid.
+ [* icon_caution] Do not hold the braid while using it as it gets very hot, and has the potential to burn you
[* icon_note] Be careful not to lay the desoldering braid across the fiberglass circuit board. As the braid heats up, it could leave marks in the board.
[* black] The solder should flow from the joint to the desoldering braid. After the solder flows into the braid, remove it and the soldering iron from the board. You should now have a clean contact to start over with. Use wire cutters to cut off the used end of the desoldering braid.