Ga door naar hoofdinhoud

Wijzigingen in stap #8

Bewerken voor David Hodson

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Insert wisdom hereWe all make mistakes, especially when trying something new. Soldering is no exception, so here's what to do when one of your soldered joints comes out less than ideal.
[* black] Lay a strand of desoldering braid over the solder in question. Press the tip of the soldering iron firmly onto the desoldering braid. This will heat up both the solder and the wick.
[* icon_note] Be careful not to lay the desoldering braid across the silicone circuit board. As the braid heats up, it will burn marks into the board.
[* black] After the solder flows into the desoldering braid, remove it and the soldering iron. You should now have a clean contact to start over with. Use cutting pliers to cut off the used end of the desoldering braid
.
[* black] Insert wisdom hereWe all make mistakes, especially when trying something new. Soldering is no exception, so here's what to do when one of your soldered joints comes out less than ideal.
[* black] Lay a strand of desoldering braid over the solder in question. Press the tip of the soldering iron firmly onto the desoldering braid. This will heat up both the solder and the wick.
[* icon_note] Be careful not to lay the desoldering braid across the silicone circuit board. As the braid heats up, it will burn marks into the board.
[* black] After the solder flows into the desoldering braid, remove it and the soldering iron. You should now have a clean contact to start over with. Use cutting pliers to cut off the used end of the desoldering braid
.