Ga door naar hoofdinhoud

Wijzigingen in stap #8

Bewerken voor Evan Noronha

Bewerking goedgekeurd door Evan Noronha

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] We all make mistakes, especially when trying something new. Soldering is no exception, so here's what to do when one of your soldered joints comes out less than ideal.
[* black] Lay a strand of desoldering braid over the solder in question. Press the tip of the soldering iron firmly onto the desoldering braid. This will heat up both the solder and the braid.
[* icon_caution] Do not hold the braid close to the solder point while using it as itit—it gets very hot,hot and has the potential tocan burn youyou.
[* icon_caution] Do not hold the braid close to the solder point while using it as itit—it gets very hot,hot and has the potential tocan burn youyou.
[* icon_note] Be careful not to lay the desoldering braid across the fiberglass circuit board. As the braid heats up, it could leave marks in the board.
[* black] The solder should flow from the joint to the desoldering braid. After the solder flows into the braid, remove it and the soldering iron from the board. You should now have a clean contact to start over with. Use wire cutters to cut off the used end of the desoldering braid.