Ga door naar hoofdinhoud

Wijzigingen in stap #23

Bewerken voor Jake Devincenzi

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* red] Locate the semi-circle labeled "T1"'''T1''' and insert the three leads through the holes.
[* icon_note] Make sure that you line up the flat part of the transistor with the flat edge of the semi-circle on the board. The two end leads fit into the holes on the ends of the flat part of the drawing. The middle lead will need to be bent so that it feeds through the hole closest to the "T1"'''T1'''.
[* red] Locate the semi-circle labeled "T1"'''T1''' and insert the three leads through the holes.
[* icon_note] Make sure that you line up the flat part of the transistor with the flat edge of the semi-circle on the board. The two end leads fit into the holes on the ends of the flat part of the drawing. The middle lead will need to be bent so that it feeds through the hole closest to the "T1"'''T1'''.
[* black] Solder the three leads to the board and cut the excess wire.