Ga door naar hoofdinhoud

Wijzigingen in stap #19

Bewerken voor Jake Devincenzi

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] The next component we will be installing is the yellow capacitor. Capacitors store electrical energy, and are helpful when a circuit needs a quick shot of energy to illuminate a light or make a beep.
[* black] Capacitors are measured (in Farads) as the ratio of the electrical charge on each conductor to the potential difference between them. This capacitor is a 1 µF capacitor.
[* red] Install the capacitor in the terminal next to the IC socket marked C1'''C1'''. Soldering the leads of a capacitor follows the same through-hole procedure used thus far.
[* red] Install the capacitor in the terminal next to the IC socket marked C1'''C1'''. Soldering the leads of a capacitor follows the same through-hole procedure used thus far.
[* icon_note] Make sure that the printed markings on the capacitor face away from the IC socket so that you can still read it.