Ga door naar hoofdinhoud

Wijzigingen in stap #19

Bewerken voor David Hodson

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Capacitor time! This yellowThe next component we will be installing is called athe yellow capacitor. Its job is toCapacitors store electrical charge, blocking direct currentenergy, and allowing alternating currentare helpful when a circuit needs a quick shot of energy to pass.illuminate a light or make a beep.
[* black]
Capacitors are measured (in Farads) as the ratio of the electrical charge on each conductor to the potential difference between them. This capacitor is a 1 µF capacitor.
[* red] Locate the two holes labeled C1.
[* black]
Install the capacitor in the terminal next to the IC socket marked C1. Soldering the leads of a capacitor follows the same way withthrough-hole procedure used thus far.
[* icon_note] Make sure that
the printed 105 facingmarkings on the capacitor face away from the IC socket so that you can still read it.
[* black] Capacitor time! This yellowThe next component we will be installing is called athe yellow capacitor. Its job is toCapacitors store electrical charge, blocking direct currentenergy, and allowing alternating currentare helpful when a circuit needs a quick shot of energy to pass.illuminate a light or make a beep.
[* black]
Capacitors are measured (in Farads) as the ratio of the electrical charge on each conductor to the potential difference between them. This capacitor is a 1 µF capacitor.
[* red] Locate the two holes labeled C1.
[* black]
Install the capacitor in the terminal next to the IC socket marked C1. Soldering the leads of a capacitor follows the same way withthrough-hole procedure used thus far.
[* icon_note] Make sure that
the printed 105 facingmarkings on the capacitor face away from the IC socket so that you can still read it.