Ga door naar hoofdinhoud

Wijzigingen in stap #14

Bewerken voor David Hodson

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* red] Bend the leads of the small red diode and insert them into the terminal marked '''D1'''.
[* icon_note] Make sure that the cathode (marked by a small black band) lines up with the white stripe to the left of where it says '''D1''' on the circuit board.
[* icon_note] Make sure that the cathode (marked by a small black band) lines up with the white stripe to the left of where it says '''D1''' on the circuit board.
[* black] Use the same method you used to solder the resistors to the board to install the diode.