Ga door naar hoofdinhoud

Wijzigingen aan stap #14

Bewerking door David Hodson

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

-[* red] Use the same soldering techniques to install the red diode around rectangle D1 as you did to install the resistors in the previous steps.
-[* icon_reminder] Make sure that the black band on the diode lines up with the white band in the circuit board illustration.
+[* red] Bend the leads of the small red diode and insert it into the terminal marked D1.
+[* icon_note] Make sure that the cathode (marked by a small black band) lines up with the white stripe on the circuit board.
+[* black] Use the same method you used to solder the resistors to the board to install the diode.