Ga door naar hoofdinhoud

Wijzigingen in stap #13

Bewerken voor Jake Devincenzi

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Insert wisdom hereOh, hello there little buddies! Good to see you again!
[* black] These are diodes -- circuitry's "one way" signs. Their job is to make sure that current only travels in the forward direction, while blocking it from traveling in reverse.
[* black] Since they only allow current to travel in one direction, it is rather pertinent that you install them facing the correct direction. As you will notice, both of these diodes have distinguishing lines on one end.
[* black] On the top diode (the red one) there is a black band on the left end. On the bottom diode (the black one) there is a gray band on the left end. When soldering them to the circuit board, make sure that these bands line up with the printed white bands shown in the next step
.
[* black] Insert wisdom hereOh, hello there little buddies! Good to see you again!
[* black] These are diodes -- circuitry's "one way" signs. Their job is to make sure that current only travels in the forward direction, while blocking it from traveling in reverse.
[* black] Since they only allow current to travel in one direction, it is rather pertinent that you install them facing the correct direction. As you will notice, both of these diodes have distinguishing lines on one end.
[* black] On the top diode (the red one) there is a black band on the left end. On the bottom diode (the black one) there is a gray band on the left end. When soldering them to the circuit board, make sure that these bands line up with the printed white bands shown in the next step
.