Ga door naar hoofdinhoud

Wijzigingen aan stap #6

Bewerking door David Hodson

Wachtend op goedkeuring


Stap regels

[* black] Here we are: the moment of truth. It's time to get that solder flowing.
[* black] Set the tip of the soldering iron on the two parts to be connected. In this case, that's the resistor lead and the copper lead on the circuit board.
[* black] Touch your solder to the tip of your soldering iron to melt it onto the joint. Don't hold it there for more than a second or two.
[* black] Quickly--but not frantically--pull both the soldering iron and the solder away from the joint.
-[* black] Your solder should be shiny and conical. Before getting too engrossed in your workmanship, though, let's solder the other resistor lead.
+[* black] Your solder joint should be shiny and conical, and not expand beyond the copper surface lead.