Ga door naar hoofdinhoud

Wijzigingen in stap #4

Bewerken voor David Hodson

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Place the leads of the resistor through the holes on either side of the rectangle marked '''R1''' on the circuit board.
[* icon_note] It doesResistors do not matter which end faces which way when installing resistorshave to be installed in a particular orientation. Either lead can go into either hole.
[* black] Turn the board over so that the copper leadstraces are facing up and the resistor leads are pointing straight up in the air.air, as seen in the second picture
[* icon_note] It doesResistors do not matter which end faces which way when installing resistorshave to be installed in a particular orientation. Either lead can go into either hole.
[* black] Turn the board over so that the copper leadstraces are facing up and the resistor leads are pointing straight up in the air.air, as seen in the second picture
[* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30° down from vertical is acceptable.