Ga door naar hoofdinhoud

Wijzigingen aan stap #4

Bewerking door Jake Devincenzi

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

-[* black] Place the leads of the resistor through the holes on either side of the rectangle marked R1 on the circuit board.
+[* black] Place the leads of the resistor through the holes on either side of the rectangle marked ***R1*** on the circuit board.
[* icon_note] It does not matter which end faces which way when installing resistors.
[* black] Turn the board over so that the copper leads are facing up and the resistor leads are pointing straight up in the air.
[* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30^^o^^ down from vertical is acceptable.