Ga door naar hoofdinhoud

Wijzigingen in stap #3

Bewerken voor David Hodson

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] We'll start with resistor R1 in your kit, which has yellow, purple, brown, and gold rings on it (more on what these colored rings mean later).
[* black] Bend the leads of the resistor to 90^^o^^ angles about 1.5 mm away from the body of the resistor.
[* black] Turn the board over so that the copper leads are facing up and the resistor leads are pointing straight up in the air.
[*
icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30^^o^^ down from vertical is acceptable.
[* black] Turn the board over so that the copper leads are facing up and the resistor leads are pointing straight up in the air.
[*
icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30^^o^^ down from vertical is acceptable.