Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Wijzigingen aan stap #5

Bewerking door Ken

Bewerking goedgekeurd door Ken

Voor
Na
Ongewijzigd

Stap regels

[title] Trim to fit
[* black] Using a fine tip on my iron , I again used a 700 degree tip , dabbed the area with liquid flux and soldered the wire to the lead and exposed trace.
[* black] Using a fine tip on my iron , I again used a 700 degree tip , dabbed the area with liquid flux and soldered the wire to the lead and exposed trace.
[* black] When done I removed tape, cleaned flux off and trimmed wire to length.
[* black] Please Note: you must have a steady grip on your iron to attach the wire. By using a long wire, you make it easier to keep it in place as you solder and it's so thin you can remove the excess wire with little stress to the repair.