Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Wijzigingen aan stap #5

Bewerking door Ken

Bewerking goedgekeurd door Ken

Voor
Na
Ongewijzigd

Stap regels

[title] Trim to fit
[* black] After solderingUsing a fine tip on my iron , I again used a 700 degree tip , dabbed the area with liquid flux and soldered the lead and exposed trace,trace.
[* black] When done
I removed tape, cleaned flux off and trimmed wire to length.
[* black] Please Note: you must have a steady grip on your iron to attach
the wire. By using a long wire, you make it easier to keep it in place as you solder and it's so thin you can remove the excess wire with little stress to proper lengththe repair.
[* black] After solderingUsing a fine tip on my iron , I again used a 700 degree tip , dabbed the area with liquid flux and soldered the lead and exposed trace,trace.
[* black] When done
I removed tape, cleaned flux off and trimmed wire to length.
[* black] Please Note: you must have a steady grip on your iron to attach
the wire. By using a long wire, you make it easier to keep it in place as you solder and it's so thin you can remove the excess wire with little stress to proper lengththe repair.