Ga door naar hoofdinhoud

Wijzigingen in stap #1

Bewerken voor Ben Eisenman

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Use a small iPod opening tool to release the black hinge holding the hard drive ribbon cable. The tab will rotate up 90 degrees towards the logic board, releasing the ribbon cable.
[* black] Use a small iPod opening tool to release the black hinge holding the hard drive ribbon cable. The tab will rotate up 90 degrees towards the logic board, releasing the ribbon cable.
[* black] Use your forefinger to hold the ribbon cable in place; disconnect the drive from the ribbon cable.
[* icon_note] Make sure the hard drive rubber side bumpers are attached to the drive being installed. Use the hard drive rubber side bumper installation guide to accomplish this task.
[* icon_note] If necessary, the blue foam padding on the hard drive might also need to be transferred to the replacement drive.