Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Wijzigingen aan stap #3

Bewerking door Ian Rasmussen

Bewerking goedgekeurd door Adam O'Camb

Voor
Na
Ongewijzigd

Stap regels

[* black] Use a suction cup or an iSclack to pull up on the glass and create a slight gap between the glass and the metal frame.
[* icon_note] If your display is badly cracked, a suction cup may not adhere. It may help to first cover the display with a layer of packing tape. Alternatively, you can superglue your suction cup to the display.
[* black] Insert an opening pick into the gap.
[* red] There are tabs on the upper right side and upper left side where it is easier to get a tool under the display.
[* black] Slide an opening pick around the sides and bottom of the display to cut the adhesive. Apply more heat as needed.
[* icon_caution] The tape is much thinner on the bottom edge than the other three sides. Do not push the tool in too far or you will damage the screen permanently.
[* icon_caution] Work carefully—the glass is thin and will crack easily if you try to force it.
[* black] Separate the top edge last. There are antennas on both sides, so be careful not to damage them. If needed, you can use a bit of isopropyl alcohol to help weaken the adhesive.