Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #2

Bewerking door Richdave

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* black] Gently push the THIN'''THIN''' wires through the rubber end cap to create a bit of a loop on the rearrear of the assembly.
[* black] Gently push the THIN'''THIN''' wires through the rubber end cap to create a bit of a loop on the rearrear of the assembly.
[* black] Using a plastic pry tool you can pop the rubber end cap out and then lift the thin wires out of the groove in the rear of the CCFL assembly
[* icon_note] Note the thin wires are held in the groove by a small amount of adhesive.
[* black] Run the pry tool the length of the assembly and free the wires all the way to the other end cap