Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #1

Bewerking door Richdave

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* black] Remove the white tape from either end of the rear of the CCFL assemblyassembly.
[* black] Remove the white tape from either end of the rear of the CCFL assemblyassembly.
[* red] Carefully remove about 15-20mm of heat shrink from the CCFL cable to allow the end cap to be removed, making sure you '''DO NOT''' cut or nick the wire insulation.
[* icon_caution] The wires have a '''HIGH VOLTAGE''' applied during operation and the insulation may break down if damaged causing a short
[* violet] While holding the assembly, slowly and gently pull the thick'''THICK''' wires up and out of the slots in the white rubber cap.
[* violet] While holding the assembly, slowly and gently pull the thick'''THICK''' wires up and out of the slots in the white rubber cap.
[* icon_caution] Pull the wires one at a time ensuring you don't flex the CCFL and break it.
[* yellow] This will reveal the pins and solder joints.