Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #1

Bewerking door Andrew Bookholt

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* icon_caution] Before heating up the motherboard, be sure to clean the old thermal paste off both the CPU and GPU until they are as clean as the processors seen in [guide|3550|this|stepid=16981] stepthe first picture. The process for cleaning the processors can be found [guide|3550|here|stepid=16981].
[* black] Lay the motherboard with the processor side facing down on the flat metal bottom of the the bare chassis (with its open side facing down) as seen in the second picture. Allow the tall USB socket to hang over the edge of the chassis so the board sits flat.
[* icon_caution] Before heating up the motherboard, be sure to clean the old thermal paste off both the CPU and GPU until they are as clean as the processors seen in [guide|3550|this|stepid=16981] stepthe first picture. The process for cleaning the processors can be found [guide|3550|here|stepid=16981].
[* black] Lay the motherboard with the processor side facing down on the flat metal bottom of the the bare chassis (with its open side facing down) as seen in the second picture. Allow the tall USB socket to hang over the edge of the chassis so the board sits flat.
[* black] Use a heat gun on the '''LOW''' setting to heat the entire back of the motherboard for '''one minute'''. Be sure to continually sweep the heat gun back and forth across the face of the motherboard to evenly heat it.

Afbeelding 1

Oude versie

Nieuwe versie

Afbeelding 2

Oude versie

Nieuwe versie

Afbeelding 3

Geen vorige afbeelding

Toegevoegd