Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Wijzigingen aan stap #3

Bewerking door suprapto

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* red] Remove the two 1.9mm Phillips #00 screws securing the vibrator to the rear panel.
[* black] Lift the vibrator up and out of the iPhone.
[* black] Keep these screws separate from the others as these have a smaller diameter than the others.
[* black] Tip: When reassembling the vibrator, make sure it is in the lowest and right most position as possible to the base of new casing. Bend down the vibrator holder on the new casing if necessary. If the vibrator placed exceeding the main board surface. If main board or front assembling touch the vibrator, it will not turn on.