Ga door naar hoofdinhoud

Wijzigingen in stap #5

Bewerken voor Brian

Wachtend op goedkeuring

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* black] Next step will be to make the edge connector out of a scrap piece of PCB.
[* black] I chose a scetion ofsection with ground plane on at least one side. It was sanded down to fit and scored to make 4 'traces'. This one pictured had a via in exactly the wrong place and it had to be drilled out.
[* black] I chose a scetion ofsection with ground plane on at least one side. It was sanded down to fit and scored to make 4 'traces'. This one pictured had a via in exactly the wrong place and it had to be drilled out.