Wijzigingen aan stap #8
Bewerken voor johnsawyercjs —
Bewerking goedgekeurd door Arthur Shi
- Voor
- Na
- Ongewijzigd
Stap regels
| - | [* yellow] While holding up the upper case, pull up the black tab of the silver cable away from |
|---|---|
| - | [* icon_note] If there is no black tab, you can also use a spudger to gently pry the |
| + | [* yellow] While holding up the upper case open, pull up the black tab, on the plug end of the silver cable, away from the plug's socket on the logic board. |
| + | [* icon_note] If there is no black tab, you can also use a spudger to gently pry the plug out of its socket on the logic board. This plug is tall, so be sure to pry straight up. |
| [* icon_note] If you happen to break your upper case cable when removing the upper case, we stock the [product|IF186-092|cable] individually and we have a [guide|4660|guide] that makes replacing it easy. | |
| [* icon_note] While you have the upper case removed, it's a good time to remove dust, hair, etc. It's best to use a can of compressed air, though if you use a brush, make sure that its bristles are made of a material (usually animal hair) that doesn't generate static electricity, which can destroy electronics. | |
| - | [* icon_note] Upon reassembly, there are 4 grey plastic clips on the optical drive side of the keyboard (refer to second picture). They must be installed in their slots for the keyboard to snap in properly. |
| - | [* icon_note] To make the reassamble process easier, it's better to pull out the clips first by pulling it straight up gently. Be careful not to use too much strength because it will break. |
| + | [* icon_note] Upon reassembly, there are 4 grey plastic clips installed in slots running along the top of the frame in front of the optical drive (refer to second and third pictures). These clips must be installed in their slots for their mating tabs on the underside of the right side of the upper case to snap into them. |