Ga door naar hoofdinhoud

Wijzigingen aan stap #26

Bewerking door Scott Havard

Bewerking goedgekeurd door Scott Havard

Voor
Na
Ongewijzigd

Stap regels

-[* black] Slide a plastic card underneath the center of the motherboard, pushing it in as far as it will go.
-[* black] Slowly swing the left edge of the motherboard up, while making sure it doesn't snag against any of the disconnected cables.
-[* icon_caution] If any portion of the motherboard requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.
+[* black] Slide a plastic card underneath the center of the logic board, pushing it in as far as it will go.
+[* black] Slowly swing the left edge of the logic board up, while making sure it doesn't snag against any of the disconnected cables.
+[* icon_caution] If any portion of the logic board requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.