Ga door naar hoofdinhoud

Wijzigingen in stap #1

Bewerken voor Adam O'Camb

Bewerking goedgekeurd door Adam O'Camb

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* icon_note] Place theOpening your phone facedownwill compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.
[* icon_note] Place theOpening your phone facedownwill compromise its waterproof seals. Have replacement adhesive ready before you proceed, or take care to avoid liquid exposure if you reassemble your phone without replacing the adhesive.
[* icon_note] If your glass is shattered, put packing tape over the entire panel to hold it together during the removal process.
[* black] Lay the iOpener[guide|25705|Prepare an iOpener|new_window=true] and lay it over thethe rear panel for about 60 secondstwo minutes to loosen the adhesive around the edge of the glass.
[* icon_note] You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.

[* black] Shift the iOpener to heat the remaining section of the panel for another 60 secondstwo minutes.
[* black] Lay the iOpener[guide|25705|Prepare an iOpener|new_window=true] and lay it over thethe rear panel for about 60 secondstwo minutes to loosen the adhesive around the edge of the glass.
[* icon_note] You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating.

[* black] Shift the iOpener to heat the remaining section of the panel for another 60 secondstwo minutes.
[* icon_caution] A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the OLED display and internal battery are both susceptible to heat damage.