Ga door naar hoofdinhoud

Wijzigingen in stap #1

Bewerken voor Sandman619

Bewerking geweigerd door Evan Noronha

Verwijderd
Toegevoegd
Ongewijzigd

Stap regels

[* red] RemoveThere are 4 - 3.2mm philips screws which hold the four 3.2 mm Philip's screws located on the backside oflens (image 1). Orient the camera around the edges connectingback facing you and remove only 3 screws, top left and both bottom screws. The top right retains the lens to the casinggears.
[* icon_note] Be careful when removingTo avoid striping the screws to not strip themscrews, check that the size of the driver is a match by applying enough pressureturning the driver back and rotating inforth to see if there is any play, ie the proper direction.
[* icon_caution] Do not remove the top right Philip's screw because
driver can turn in both directions freely before engaging the lens' gears may fall outscrew.
[* red] RemoveThere are 4 - 3.2mm philips screws which hold the four 3.2 mm Philip's screws located on the backside oflens (image 1). Orient the camera around the edges connectingback facing you and remove only 3 screws, top left and both bottom screws. The top right retains the lens to the casinggears.
[* icon_note] Be careful when removingTo avoid striping the screws to not strip themscrews, check that the size of the driver is a match by applying enough pressureturning the driver back and rotating inforth to see if there is any play, ie the proper direction.
[* icon_caution] Do not remove the top right Philip's screw because
driver can turn in both directions freely before engaging the lens' gears may fall outscrew.