Ga door naar hoofdinhoud

Wijzigingen aan stap #7

Bewerking door William

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* black] Use a paperclip and bend one of the ends to form a prying tool.
[* red] Insert the end of the paperclip into the hole located in the middle of the ribbon in order to maneuver the ribbon out of its connector.
[* icon_caution] Be careful when applying pressure to not tear the ribbon.
-[* blue] Remove the square connector at the top of the logic board as indicated in the picture. Grab this connector with two fingers and pull upwards till it detaches.

Afbeelding 1

Oude versie

Nieuwe versie