Ga door naar hoofdinhoud

Wijzigingen aan stap #5

Bewerking door William

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

-[* red] Remove the two 3.46 mm Philip's screws connecting the logic board to the frame of the camera.
- [* icon_note] The heads of these two screws are completely flat,while most of the other screws found within this camera have a rounded head.
-[* yellow] Disconnect the ribbon at the bottom of the main board, as indicated in the picture, by rotating the brown connector upwards and pulling the ribbon out.
-[* blue] If the flash is not removed, remove the right most square connector at the bottom of the camera. Grab the connector with two fingers and pull upwards till it detaches.
-[* icon_note] Do not lose the white rubber cover indicated by the purple square in the image. This is for the microphone.
+[* red] Remove the two silver 3.46 mm Philips screws connecting the logic board to the frame of the camera.
+ [* icon_note] The heads of these two screws are completely flat, while most of the other screws found within this camera have a rounded head.
+[* yellow] Disconnect the ribbon at the bottom of the main board by flipping up the brown ZIF connector and sliding the ribbon out.
+[* blue] If the flash is not removed, remove the right most square connector at the bottom of the camera by flipping up the connector with two fingers until it detaches.
+[* violet] Do not lose the white rubber cover for the microphone.