Ga door naar hoofdinhoud

Wijzigingen aan stap #5

Bewerking door William

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

-[* red] Remove the two silver 3.46 mm Philips screws connecting the logic board to the frame of the camera.
- [* icon_note] The heads of these two screws are completely flat, while most of the other screws found within this camera have a rounded head.
[* yellow] Disconnect the ribbon at the bottom of the main board by flipping up the brown ZIF connector and sliding the ribbon out.
[* blue] If the flash is not removed, remove the right most square connector at the bottom of the camera by flipping up the connector with two fingers until it detaches.
[* violet] Locate the white rubber cover on the microphone.
[* icon_caution] Be sure not to lose the white rubber cover for the microphone.

Afbeelding 1

Oude versie

Nieuwe versie