Ga door naar hoofdinhoud

Wijzigingen aan stap #5

Bewerking door William

Wachtend op goedkeuring

Voor
Na
Ongewijzigd

Stap regels

[* red] Remove the two 3.46 mm Philip's screws connecting the logic board to the frame of the camera.
[* icon_note] The heads of these two screws are completely flat,while all of the other screws found within this camera have a rounded head.
[* yellow] Disconnect the ribbon at the bottom of the main board, as indicated in the picture, by rotating the brown connector upwards and pulling the ribbon out.
[* blue] If the flash is not removed, remove the right most square connector at the bottom of the camera. Grab the connector with two fingers and pull upwards till it detaches.
+[* icon_note] Do not lose the white rubber cover indicated by the purple square in the image. This is for the microphone.

Afbeelding 1

Oude versie

Nieuwe versie